18
Component Test Procedures
FTS-XX112L Symptom Diagnostic Table
Before start:
•
Check if the By-pass is off (optional, depending on the OEM).
•
Check if the air supply is dry and clean.
•
Check if there is air leakage on pneumatic system, like lose nipples, damaged hoses, etc.
•
Check if the vehicle has 8.0 bar or more.
•
Set the key at the on position, don't start the engine.
All range shifts happen during the neutral position, so perform all tests with the lever in Neutral position.
SYMPTOM
COMPONENT
PROCEDURE
OUTPUT
ACTION
Low range
doesn’t work
Pilot air line
•
Remove the air line P at
range valve
•
Select low range at the
knob
There is air supply
None
There isn’t air sup-
ply
•
Check if there is air
leakage through P air
line
•
Check if the knob is
supplying air to air
line P. If not, replace
the knob.
•
Remove the air line P at
range valve
•
Select high range at the
knob
There is air supply
None
There isn’t air sup-
ply
•
Check if P has been
replaced by SP
•
Check if the knob is
supplying air in high
range. If yes, replace
the knob.
IMPORTANT
Summary of Contents for TRTS4400
