12
www.eaton.com/wireless
call toll free: 1-800-663-8806
DMAN-4096-01 R1
Service Mode
Service Mode is available on the TS110 one-way RCU and allows the operator to pair to a Base Station, adjust the
RCU’s timeout, run diagnostics, and optionally configure the Base Station outputs in the field.
Once the RCU has entered into Service Mode, navigation and option selection/modification is controlled by four
buttons as described by the
Enter Service Mode
and
Navigation
sections below.
Enter Service Mode
A. Press and Hold Power OFF
[RED]
B. Press and Hold Power ON
[GREEN]
Wait for the COMM LED to be turned ON, then immediately
proceed to next step.
C. Release Power OFF
[RED]
D. Release Power ON
[GREEN]
The COMM LED
will blink YELLOW when unit enters Service
Mode.
Once in Service Mode, the RCU will automatically turn OFF when
left idle (no buttons pressed) for 5 minutes.
A.
B
.
C.
D.
Navigation
Once you have entered Service Mode you can select the Service
Mode options listed below
The Power ON
[GREEN] will allow you to execute or modify an
option. Power OFF
[RED] will allow you to move up from an
entry and power off the unit. Only one option is allowed at a time in
Service Mode. Service Mode options are as listed below
A. Button
[GREEN] - Start pairing TS110
B. Button
- Modify RCU timeout
C. Button
- Run Diagnostics
D. Button
- Software build version
COMM LED
Light Legend
Solid
Slow
Flash
Fast
Flash
Red
Solid
Green
Solid
Red & Green
Alternating
Yellow
Solid
NOTE:
Only properly equipped R160 Base Stations may be configured in the field.
