8
InstALLAtIon And opErAtIon MAnUAL
25-13400-C May 2019 www.eaton.com
4.2 Stainless Steel Flush Mount (EFVCC5-FC)
If the VoCALL 5 is to be fitted with the Stainless Steel Flush Mount option
(EFVCC5-FC), the dimensions of the hole cut into the wall must only exceed the
dimensions of the panel by a maximum of 20mm on all sides.
The flush cover provides a 25mm border around the outside dimensions
of the panels.
For correct fitting of the flush mount cover, the VoCALL 5 back box should be
recessed into the wall so that the front of the unit is level with the finished surface
of the wall. The flush plate will then sit flat on the wall and the front of the unit once
the 4 countersunk screws are fitted.
Be aware that the flush plate is heavier than the standard cover, and therefore
special care should be taken to ensure the fixings are adequate to support the panel.
For full dimensions see “10. Technical Specification” on page 18.
Figure 3. Mounting the Flush Mounted panel. EFVCC5-FC should be
procured separately.
