xComfort Room Controller Touch User Manual 1v00_EN
6 |
P a g e
2.5.3 Temporarily adjust the current set-point temperature
It is possible to temporarily increase or decrease the current set-point temperature. The temporary
increase or decrease in the set-point temperature will be reset to zero when the operation mode (pre-
defined set-point temperature) is changed, either manually or via the Week Program Timer.
Note:
To change the set-point temperature permanently, see the following section:
‘Edit
Operating Instructions - Change Pre-Defined Temperature Set-point’.
Initial
Step 1
Optional Selection of
Heating or Cooling set-
point
Step 2
Idle
Timeout
2.5.4 Switch active set-point temperature (operation mode)
The Room Controller Touch supports four different pre-defined and reprogrammable set-point
temperatures (operation modes) for an easy change in the desired (set-point) temperature during the
day. It is possible to manually switch between these pre-defined set-point temperatures.
The pre-defined set-points can also be used in the Week Program (when enabled) to switch
automatically between the different set-point temperatures on a timed basis,
Note:
The Week Program will be switched OFF when the active set-point temperature (operation
mode) is changed manually.
