xComfort Room Controller Touch User Manual 1v00_EN
1 |
P a g e
1. Introduction
1.1 Safety instructions
This document contains important warnings and safety instructions which must be observed and
followed by the users. Failure to follow these warnings and safety instructions will put the fault-free
operation of the Room Controller Touch at risk.
1.2 Intended use
The Room Controller Touch has been designed solely for residential use in private homes and small
offices. It is not suitable for industrial use.
The Room Controller Touch is designed to facilitate the climate control in a room and provide the user
access to this through an intuitive LCD Touch screen menu.
The Room controller can operate in two application modes:
•
Control mode
; in which the Room Controller Touch controls the regulation of the climate in a room
•
Sensor mode
; in which the Room Controller Touch registers the room climate conditions and the
user settings and sends them to an intelligent device, e.g. xComfort Smart Home Controller (SHC),
which actually controls the climate in the room.
Since the transmission of radio signals is based on a non-exclusive communication channel,
interference to the transmission are possible. Because of this, the Room Controller Touch
must not be used to control components with safety-related functions, such as
overheating protection, emergency stop or emergency call.
The use of the unit for any purpose other than described in this document or the failure to observe the
warnings and safety instructions it contains will immediately invalidate any claims in respect to the
warranty and/or liability.
1.3 Instructions for disposal
Do not dispose of this device with regular domestic waste.
Electronic equipment must be disposed of at local collection points for waste electronic
equipment and in compliance with the local regulations governing waste electrical and electronic
equipment.
1.4 About this document
These operating instructions are intended for end users and describe the operation and menu structure
of the Room Controller Touch.
Certain functions and their availability depend on the configuration of the Room Controller Touch during
the installation. These functions are marked with
(Optional).
Please contact a suitable qualified electrical engineer for all assembly, installation and
basic configuration requirements or if you need to remove or dispose of the device.
Faulty installation or configuration can otherwise cause damage to property and persons.
