6 Application example: XNE gateway with an Allen Bradley PLC
6.5 Configuration of the network in "RSLogiX 5000"
XI/ON: XNE-GWBR-2ETH-IP
09/2011 MN05002007Z-EN
www.eaton.com
163
Open "Communications" and select the bridge. In this example this would be 1756-ENBT/A.
Enter the "Major Revision" of your EtherNet/IP bridge and click "OK".
In the following dialog box "New Module" enter a name for the bridge and define its IP Address
(in this example 192.168.1.100).
In the following dialog box "Module Properties: Local..." press "OK". You may also browse
offline through the module properties when you click "Next". At this point there is no need for
further entry action. If "Next" is selected, the "Module Properties" window displays information
that will be available when the module is online. The configuration of the interface is
completed. Press "Finish" to close the dialog box.
Figure 52:
Selection of the
EtherNet/IP
bridge
Figure 53:
Major Revision
of the Ether-
Net/IP Bridge
Figure 54:
Configuring the
EtherNet/IP
Bridge
