5 Implementation of Modbus TCP
5.10 Diagnostic messages of the modules
XI/ON: XNE-GWBR-2ETH-MB
10/2011 MN05002008Z-EN
www.eaton.com
101
• XN-32DO-24VDC-0.5A-P
5.10.4
Analog output modules
• XNE-4AO-U/I
Table 52:
XN-32DO-
24VDC-0.5A-P
Diagnosis byte
Bit
Diagnosis
n
0
Overcurrent (short-circuit), channel 1-4
1
Overcurrent (short-circuit), channel 5-8
2
Overcurrent (short-circuit), channel 9-12
3
Overcurrent (short-circuit), channel 13-16
4
Overcurrent (short-circuit), channel 17-20
5
Overcurrent (short-circuit), channel 21-24
6
Overcurrent (short-circuit), channel 25-28
7
Overcurrent (short-circuit), channel 29-32
Table 53:
XN-4AO-U/I
Diagnosis byte
Bit
Diagnosis
A
The switching
thresholds de-
pend on the set-
ting of the
module parame-
ter operation
mode Kx,
see manual
MN05002011Z
n (channel n),
n=1…4
0
Output value range error “Out of Range” (OoR)
A
:
– The set output value overstepps or undercuts the limit of the
nominal range (limit values according to parameterization).
1
reserved
2 reserved
3
Overflow / Underflow (OUFL)
A
:
– The set output value exceeds the output range (limit values
according to parameterization). The module cannot transmit
this value. The output value is the maximum or minimum
value which can be outputted.
4 to 6
reserved
7
Hardware error (HW Error):
– Exampels: CRC error, calibration errors…
– The output value of the analog value is “0”.
