4 Technical Features
4.5 Address setting
36
XI/ON: XNE-GWBR-2ETH-MB
10/2011 MN05002008Z-EN
www.eaton.com
Table 5:
Meaning of the
DIP-switches
Designation
Function
2
0
- 2
7
Address-switch for setting the last byte of the gateway’s IP-address,
only if the "MODE" switch is set to "OFF" (see Table 6: Combinations
for the address-switch settings, Page 36).
MODE
Depending on its setting, this switch changes the function of address-
switches 2
0
- 2
7
(see Table 6: Combinations for the address-switch
CFG
Switching from "OFF" to "ON" activates the storage of the station
configuration (see Chapter 4.6 Storing the station configuration,
Page 44.)
Note
The position of the DIP-switches 2
7
, CFG and MODE is also important for the down-
load of new firmware to the gateway. Please read Chapter 7.7 Firmware download,
Page 147.
Table 6:
Combinations
for the address-
switch settings
Address switch
2
0
- 2
7
Address switch
"MODE"
Function
0
OFF
Setting the „Default-settings for the gateway”.
1-254
OFF
„Address-setting via DIP-switches 20 to 27”
(Setting the last byte of the gateway’s IP-address)
1
ON
Gateway-„Address setting via DHCP-mode”
2
ON
Gateway-„Address setting via BootP-mode”
4
ON
Gateway-„Address setting via PGM-mode”
8
ON
invalid
