2. Safety regulations
2.3 Device-specific hazards
CAUTION
POINTY, SHARP OBJECTS AND CORROSIVE LIQUIDS
When cleaning the XP-504:
l
Do not use any pointy or sharp objects (e.g., knives).
l
Do not use aggressive or abrasive cleaning products or solvents.
Make sure that no liquids get into the XP-504 unit (short-circuit
hazard) and that the XP-504 unit is not damaged in any way.
CAUTION
INSTALLATION CUT-OUTHUMAN-MACHINE INTERFACE
The mounting cutout for Panel-PC, Widescreen terminal and Terminal
with Extender RX must be located in a position that will not defeat the
purpose of stabilizing webs or other reinforcing elements in the con-
trol panel. If necessary, reinforcing elements must be instal-
led/added.
An IP65 degree of protection will only be ensured if there is sufficient
stiffness and the device is properly mounted.
l
Minimum sheet thickness of control cabinet where the device will
be flush mounted:
1.5 mm (0.06“) ≦ d ≦ 4 mm (0.16“)
l
In order for the device to be properly mounted, every single one of
the holding brackets must be used at its intended spot.
CAUTION
When using commercially available peripheral devices (e.g., with the
USB port), it is important to keep in mind that their EMC interference
immunity parameters may render them unsuitable for use in industrial
environments.
The USB and HDMI Connectors are for maintenance only, except
when installed together with strain relief metal plate with the cable
ties provided.
XP-504
04/2022 MN048028EN Eaton.com
37
Summary of Contents for XP-504-10-A10-A01-2B
