EAU FLOW 505
FOR HELP & ADVICE, PLEASE EMAIL
technical@cleancert.co.uk
OR CALL
08443 511115
Installation
1. Connect up all components as shown on the ‘Fitting Instructions’ sheet.
2. Ensure valve on top of storage tank is in ‘off’ position (90 degrees to tubing)
and dispensing point (valve or tap) is ‘open’.
3. Connect the electricity and water supply to the RO and turn on.
4. Allow water to flush through cartridges and run from dispensing point
(valve or tap) for 5 minutes down the drain.
5. Now close the dispensing point (valve or tap) and open the valve on top of
storage tank (inline with tubing)
6. Allow storage tank to fill
(around 45 minutes for a 12L tank, 60 mins for 20L, 90 mins for 40L)
7. Do not use first tank of water- allow to run down drain by opening
dispensing point (valve or tap)
8. Allow tank to refill - system is ready for use.
Mains Connection Diagram
Double check valve
Appliance tap
Washer
1/4” Pipe supplied
3/4” BSP thread
15mm cold water supply
15mm copper pipe (not supplied)
Connection and filling
