6.2 Function Chec
12
k
After connecting the wire of the system module, it is necessary to check whether the
links and functions of each module are normal. The function check must be completed
when the propeller are unloaded. The steps are as follows:
6.2.1 Communication Check
Turn on the power of the UAV and the remote control (the communication mode
Figure 6 Connect to the Remote Contro
of the remote control should be switched to the mode that is compatible with VK-fly,
you can set it on the remote control APP). Enter
EAVision
Agriculture APP, tap Settings
→ Controller → Bluetooth. Select the Bluetooth of the remote control (start with 300)
and the operation model (left throttle model). There will be voice broadcast "the
remote control has been connected" if the remote control is connected. You can see
the amount of rudder travel of the remote control channels in the "Channels" page;
you can see the status of the Flight Control in the "Debug" page.
l
