13
6.2.2 Remote Control Calibration
Compare with the amount of rudder travel of the remote control channels on the
APP and confirm whether the amount of rudder travel of the remote control channels
need to be reversed. If the definition of pros and cons of the channel is not in
accordance with what the APP displays, then the amount of rudder travel need to be
reversed in the debug software of the remote control. Check whether the rudder travel
range of channel 1-4 are from 100 to 200, and whether the rudder travel range of
channel 5-8 are from 110 to 190. The channel error should be no more than 3%. If it is
more than 3%, the remote control should be calibrated. The calibration steps are as
follows:
Set the pros and cons of each channel and return all the rockers of the remote
control to zero. Set all the channel curves to default.
Put the rocker and the key in the middle position, tap "Calibrate Controller" in
the "Calibration" page on the APP or toggle Channel 7 for 6 times to enter
calibration mode, the LED light will become purple and it will flash 3 times,
which means that it has entered calibration mode. Then push the corresponding
rocker or key of all channels (Channel 1-8) to make it move to the maximum
working range and repeat several times.
Then tap "Confirm" on the APP interface or toggle Channel 7 for 6 times again
to exit calibration mode. When the LED light flashes as normal (purple light
goes out), it means the calibration is completed.
