15
6.2.3 Motor Check
1）
ESC Calibration
Remove the blades, push the aileron and accelerator of the remote control to the
maximum at the same time, and then power on the flight control and the ESC
concurrently, the flight control will enter the ESC calibration mode, purple light flashes
4 times. The ESC will make a dripping sound. It means that the ESC has entered the
calibration mode. Return the aileron to the middle and pull the throttle to the lowest
level, the ESC will make a dripping sound again, which means that ESC calibration is
completed.
Warning: The calibration must be conducted after the blades were removed.
2）
Motor Check
Turn on the main battery to enter the "Motors" page. Tap the "Check" button of
Motor 1 to Motor 4 in order to check the steering of the motor. When the motor was
being checked, if the signal was shown on the APP, but the motor didn't work, adjust
the idling level of the motor to a higher level in "Advanced → Algorithm".
Figure 8 Steering Check of the Motor
