20
8.
On the Caster Pallet, remove the four quick-release pins linking it to the bottom module,
releasing the stack from the Caster Pallet.
9.
Verify that the bottom module’s Rigging Latches are fully retracted and inspect the entire
array. When an array is properly and safely flown, the ONLY orange that should be visible will
be on the Latches of on the bottom-most module.
ANY OTHER VISIBLE ORANGE ON THE
ARRAY INDICATES A PROBLEM AND MUST BE ADDRESSED BEFORE CONTINUING
.
Once this
inspection is complete, fly out to trim height (if a complete array).
(Fig. 4)
10.
If array is not complete, raise it high enough to clear the next stack of Otto modules and repeat
from Step #2 above.
Summary of Contents for ADAPTive systems
Page 1: ...Accessory Rigging Guide...
