c
arE
& h
andling
• Do not submerge into water or other liquids.
• Do not disassemble the product for any
reason.
• Do not expose to extreme temperatures.
• Do not drop, throw, smash or otherwise
cause physical shock.
• Clean using only a slightly damp cloth.
• Do not use cleaners with chemical agents.
b
aTTEry
i
nFormaTion
• Do not short-circuit the battery terminals.
• Non-Rechargeable batteries are not to be
charged.
• Do not mix old and new batteries.
• Remove exhausted batteries.
• Batteries should be installed and replaced by an
adult only.
• Remove batteries when not in use.
• Do not mix alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries.
• Only batteries of the same or equivalent type as
recommended are to be used.
• Batteries are to be inserted with the correct
polarity.
• Check that the contact surfaces are clean and free
of dust or debris before installing batteries.
SAFETY WARNINGS
• Please use adult supervision when operating the Flying Truck.
• Keep hands, hair, face and loose clothing away from the propeller when power is turned on.
• Turn off the controller and truck when not in use.
• Do not fly the truck over a person’s head.
• Do not use the controller to charge batteries other than the one built into the Flying Truck.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursu-
ant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Controller
Power: DC
Requires: 6 x AA 1.5V
Truck
Power: DC
Requires: 1 x 3.7V rechargeable battery
(built in)
s
PEcial
b
aTTEry
i
nFormaTion
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
