5
TRIMMING HELICOPTER/DIRECTION CONTROL
Virtually no trimming is required for the
Night Raider
. However, if the helicopter
ight, use the Rudder Trim Knob on the top right side to adjust.
1. When the helicopter is spinning clockwise, turn the Rudder Trim Knob
counterclockwise to adjust. (See Diagram A)
2. When the helicopter is spinning counterclockwise, turn the Rudder Trim
Knob clockwise to adjust. (See Diagram B)
nger while
controlling the turning with your right thumb and controlling the height
with your left thumb.
FLIGHT CONDITIONS
ight conditions
are optimal before launch.
•
This chopper was built for indoor terrain only with minimal wind conditions.
Heavy air-conditioning can be too strong for this chopper resulting in a
“Mayday” situation.
all electric fans, air conditioning
ying.
ight be at least 10 ft. x 15 ft. x 10 ft.
CONTROL TIPS
•
It is best to start with both joysticks on the remote control in the middle
position. Do not immediately push into extreme positions. Instead start by
gently easing the joystick into the direction you would like to go.
ight, EXRC recommends focusing on learning to control the
rst. Try to keep the helicopter at a constant 3-foot altitude
before attempting to learn directional control. After you have mastered the
throttle joystick, then start to practice turning with the directional joystick.
A
B
