CAUTION – Battery Safety Information
• Non-rechargeable batteries are not to be recharged
• The pre-installed battery is non-replaceable
• Rechargeable batteries should only be recharged under adult supervision
• Do not mix alkaline, standard (carbon-zinc), or rechargeable
(nickel-cadmium)
batteries
• Exhausted batteries are to be removed
• Do not mix old and new batteries
• Do not dispose of product in fi re; batteries may explode or leak
• If this product will not be used for an extended period, remove the
batteries from the product
• The supply terminals are not to be short-circuited
• Batteries are to be inserted with correct polarity
• Clean the battery contacts and also those of the product prior to
battery
installation
• As always, dispose of batteries in an eco-friendly manner
FCC Part 15 Compliance
The device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation. Changes or modifi cations not expressly approved by the party responsible for compliance could void the
user’s authority to operate the product.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the transmitting equipment and receiver.
•
Connect the equipment into an outlet on a circuit diff erent from that to which the receiver is connected.
•
Consult the dealer or an experienced radio technician for help.
EB Excalibur, Inc.
Miami, Florida
www.EBExcalibur.com
service@ebexcalibur.com
Distributed in the United Kingdom by:
EB Brands UK, Worcester WR4 9FA
Actual product may diff er slightly from photography.
XC9970IS01EXCRA
XC9970IS01EXCRA.indd 8
XC9970IS01EXCRA.indd 8
7/28/11 2:35 PM
7/28/11 2:35 PM
