ON
-10-
Memorization of TX and RX
Before starting the memorization, put dip-switch 4 of the tx as shown:
1
1 2
2
3
3
4
4
ON
1
1 2
2
3
3
4
4
DIP 4 - TX
OFF
Memorization IN 1
DIP 4 - TX
ON
Memorization IN 2
NC
NC
IN. 1
IN. 2
How to learn a code on OUT 1 (RX)
How to learn a code on OUT 2 (RX)
To associate one safety edge to the output OUT1 in the receiver do as follow:
1. Press once the P1 PROG of the receiver, LED TX1 fl ashes once.
2. Press P1 of the transmitter within 60 seconds after pressing P1-PROG.
3. If the buzzer beeps it means that the operation is confi rmed, if the TX is already memorized the buzzer
beeps three times.
4. Once the memorization has been fi nished , the receiver goes automaticall and the LED RX1 turns off.
If you need to memorize extra transmitters starts from point 1 again.
To associate one safety edge to the output OUT2 in the receiver do as follow:
1. Press twice the P1 PROG of the receiver, LED TX1 fl ashes once.
2. Press P1 of the transmitter within 60 seconds after pressing P1-PROG.
3. If the buzzer beeps it means that the operation is confi rmed, if the TX is already memorized the buzzer
beeps three times.
4. Once the memorization has been fi nished , the receiver goes automaticall and the LED RX1 turns off.
If you need to memorize extra transmitters starts from point 1 again.
TRANSCEIVER
GB
Summary of Contents for NOLOGO TRANSCEIVER-RX
Page 2: ......
