15
5
Gestione TELECOMANDI
La scheda elettronica è in grado di gestire diversi tipi di codice, il primo telecomando appreso ne determinerà il tipo, di conseguenza, non si possono
apprendere telecomandi con tipo di codice differente dal primo telecomando appreso.
I codici gestibili sono gli standard da 12 a 64 bit e per i codici rolling tipo HCS© solo la parte fissa, non il controllo del contatore rolling.
Il primo trasmettitore appreso determina il tipo di codice che la ricevente deve gestire, di conseguenza i trasmettitori successivamente appresi devono
avere lo stesso tipo di codice.
5.1 CANCELLAZIONE della memoria CODICI
Questa operazione cancella tutti i codici presenti in memoria. Per la cancellazione di un singolo codice passare al paragrafo
successivo.
E’ necessario eseguire il reset della memoria prima di apprendere il primo telecomando in modo che non ci siano
dei codici precedentemente appresi e non utilizzati sull’impianto
.
La cancellazione del codice di un telecomando è possibile
solo ad automazione in posizione di
CHIUSO
.
Impostazione
Descrizione
C 03
Reset memoria codici
Per effettuare la cancellazione dei codici segliere l’impostazione
C03
utilizzando i pulsanti
P2
e
P3
. Poi confermare con il tasto
P1. Atten
-
dere 10 secondi come indicato dal DISPLAY,
se viene premuto il
tasto
P1
durante questi 10 secondi
l’operazione viene annullata
.
5.2 CANCELLAZIONE di un singolo codice radiocomando
Questa impostazione permette di cancellare un singolo codice di radiocomando alla volta.
Per effettuare la cancellazione dei codici segliere l’impostazione
C04
aiutandosi con i pulsanti
P2
e
P3
. Poi confermare con il tasto
P1
Ora premere il pulsante del radiocomando di cui si vuole eliminare il
codice.
Attendere la scritta CANC sul DISPLAY
Impostazione
Descrizione
C 04
Cancellazione codice
5.4 Attivazione funzione ROLLING HCS COMPLETO
Settando a 1 l’impostazione S 08, la cen
-
trale accetterà solo il codice HCS e con
-
trollerà il contatore rolling. I radiocomandi
non sono duplicabili. Se non attivato verrà
accettata comunque solo la parte fi ssa del
codice.
Impostazione
Descrizione
Valori Accettati
S 08
Funzione HCS Completo
0 Disattivato -
Default
1 Attivato
Summary of Contents for START S10
