7
2.12 Branchement de la
CELLuLE PHOTO A
(seulement en fermeture)
2 3 4 5 6 7 8 9 10
Alimentation TX
de la cellule
13 14 15 16
+
-
Recepteur de la cellule
Borne avec contact
normalement fermé
Alimentation RX
de la cellule
Si l’entrée FoTo n’est pas
utilisé, il faut programmer
S16 à “0”
Le contact du recepteur doit être:
- isolé
- normalement fermé
Plusieurs couples de photocellules
doivent être installé en serie.
2.13 Branchement
PHOTO A
avec
PHOTO-TEST
2 3 4 5 6 7 8 9 10
Alimentation TX
de la cellule
13 14 15 16 17
+
-
Alimentation RX
de la cellule
Le contact du recepteur doit être:
- isolé
- normalement fermé
Plusieurs couples de photocellules
doivent être installé en serie.
-
Le TEST sur les cellules assure le fonctionnement seulement si les cellules marchent correctement.
L’armoire fait un test avant l’ouverture.
Dans le cas les cellules ne marchent pas bien, la lampe clignote pour 5 seconds et le portaile reste fermé.
Si l’entrée FoTo n’est pas
utilisé, il faut programmer
S16 à “0”
Programmation
Val
description
S 06
1
Activation TeST pour
ENTRE TEST
(Val. Default 0)
S 22
1
Activation sortie TeST
pour PHoTo A
(Val. Default 0)
Pour activer TeST programmer PHoTo A à 1
Si on veut pas utiliser “
TEST
” il faut brancher les cellules
(voir Par. 3.12)
et programmer
S22
et
S06
à “
0
” (il faut déactiver seulement si il n’y a pas des autres entrées avec TEST)
+
-
+
-
+
-
+
-
Recepteur de la cellule
Borne avec contact
normalement fermé
Summary of Contents for START S10
