8
3.10 Collegamento FINE CORSA
Nella figura viene mostrato il collegamento di entrambe i finecorsa,
ma su questa centrale si possono utilizzare anche
singolarmente.
Quindi si può utilizzare ad esempio solo il “Finecorsa Apre” oppure solo il “Finecorsa Chiude”.
Impostazione Valore
Descrizione
S 11 0
Disattivazione
Ingresso FCA1
Val. di
Default 1
S 12
0
Disattivazione
Ingresso FCC1
Va. di
Default 1
3 4 5 6 7 8 9 10 11 12
MOT 2
MOT 1
CHIUDE
APRE
CHIUDE
APRE
I contatti dei finecorsa
devono essere di tipo N.C.
(normalmente chiuso).
Per disattivare gli ingressi
FINE CORSA
settare le impostazioni come in tabella.
Impostazione Valore
Descrizione
S 13
0
Disattivazione
Ingresso FC2
Val. di Default 1
S 14 0
Disattivazione
Ingresso FCC2
Val. di Default 1
3.11 Collegamento di un comando di APERTURA: START / PEDONALE
3 4 5 6 7 8 9 10 11 12
Il collegamento del comando di apertura START può
essere effettuato a qualsiasi pulsante o contatto di tipo
N.A. (normalmente aperto). Se vi sono più dispositivi,
vanno collegati in parallelo.
Utilizzando i morsetti 3 e 11 è possibile collegare un TIMER per programmare delle aperture del cancello. Il contatto del
timer deve essere di tipo NA (normalmente aperto) e deve restare in condizione di chiuso per tutto il tempo che il cancello
rimane aperto. Se è presente il collegamento del comando di apertura sul morsetto 16, collegare in parallelo.
Il collegamento del comando di apertura PEDONA
-
LE può essere effettuato su qualsiasi pulsante o
contatto di tipo N.A. (normalmente aperto).
Summary of Contents for START S10
