- 21 -
Programming
This control system enables you to store 99
programs with 99 programmable steps. One
step represents one measurement. After
entering the program numbers you are able to
change between several program steps with
the button
j
and
b
.
"
u
" on the display
the entered dimension
is too low.
"
o
" on the display
the entered dimension
is too high.
Each program step corresponds to one
dimension. The indicated program step can be
overwritten at any time. These programs
remain stored when the machine is off. Should
you change to another dimension unit all
programmed measurements are converted
into the new unit (cm or inch).
Entering a program
• Press
p
"
X
" appears on the display.
•
0 1
...
9 9
Enter program number
01...99.
(Top number on display
X
= program
number).
• If measurement is shown on the display
M
the program is reserved.
• Enter dimension, or move the backgauge to
the desired measurement with the handwheel.
•
g
Store the dimension
next program step
Y
appears. If the hand-wheel
G
is used to
approach the cutting position press button
b
next program step appears.
• Enter the next dimension.
Should an ejection be desired
before
this
cut press
p
, hold, and press
T
.
•
g
Store the dimension
next program
step appears.
• Should the entered program be required
immediately
press
S
(program is
closed). Press
S
again (backgauge moves
to the dimension of the first program).
Or:
•
p
+
s
Escape the program mode.
• Operation •
