Page 13
Assembly of the bottle basket
Put the template on the table and put
the bottle basket over the template.
Attention:
The template is marked with the word
FRONT
Also mark the basket with a cable tie
or the like. The basket is square, but it
only has
one correct
front.
Be aware that the skids are running
from the front to the rear.
Then put your bottle (in our example a
0.75 l flip-top bottles) on the recess of
the template.
Then mount the support rail at the
height which best allows to hold the
bottle at the bottle neck.
Then mount the lateral and rear
support rail.
Attention:
Mount the front and rear support rails
at the same height and fix them with
the screws. Only tighten the screws
slightly Mount the lateral support rails
displaced by one hole of the frame to
the bottom.
Then only slightly tighten the screws.
Only tighten the screws after having
completed the “level”.
Summary of Contents for GS 21
Page 8: ...Page 8 ...
Page 9: ...Page 9 ...