USE AND CARE FOR CATALOG NUMBER:
- E6140.00 Orbital Shaker Power Unit
Variable Speed 30-350 rpm with Timer and Tachometer
230/115V 50/60Hz
GENERAL INFORMATION
o
Handle this unit with care. Unpack and check that the contents coincide
with the packing-list. If any part is damaged or missing, please advise the
distributor immediately.
o
Do not install or use this equipment without first reading this manual.
o
This manual should always be attached to the equipment and made
available to all users.
o
If you have any doubts or inquiries, please contact your supplier or
Eberbach Corporation
technical service.
Weight/Speed Considerations:
Maximum load and maximum speed specifications for Eberbach shakers are
established both as a guide to ensure long operational life of the units and as
safety parameters for the operator. When shaking heavy loads at higher
speeds always monitor the progress of the shaking action for a few minutes.
Pay particular attention to the stability of the load as objects may shake loose
from the platform/box carrier if not properly secured. Always turn the shaker off
before adding, adjusting or removing items. Be mindful that solid masses will
affect the shaker differently than will the same mass of a fluid. If you have any
concerns about your shaking protocol please call Eberbach technical support.
OPERATION
The
Eberbach
orbital shaker catalog
# E6140.00
features:
o
A continuously variable speed range, adjustable between 30 and 350 rpm/min
with stock orbit
set to .75
” (19.0mm).
o
An Oriental BLDC Motor Drive for quiet operation and low maintenance.
o
A digital tachometer and timer for simple and accurate use.
o
A maximum shaking weight of 50lbs (23kg)
at high speed (with stock .75”
(19.0mm) orbit diameter).
Contact
Eberbach Corporation Technical Support
for other stroke setting
weight limits.
