EDO
EN
12
www.eberg.eu
LED DISPLAY AND TOUCH PANEL
Turn On / Off
To turn the device on and off, press the button:
•
on the touch control panel,
or
•
on remote control.
Ionization function
To turn on the air ionization function:
•
press and hold the button
on the control panel for 3 seconds. Another pressing and holding
this button for 3 seconds will disable the ionization function,
or
•
press the button
on the remote control. The button is used to turn this function on and off.
Timer function
•
Use the button
on the control panel or the remote control to set the humidifier operation time
after which the device will be automatically turned off. The function allows you to set the humidifier
operation time in the range of 1 - 12 hours. Each press of the button changes the setting by 1 hour.
Humidification level
The device allows you to set the desired level of humidification - the volume of the mist flowing out
through the nozzle. There are 3 levels of humidification (1-2-3).
Use the button
to set the humidification level on both the control panel and the remote control.
Pressing this button again changes the humidification level setting by 1.
Humidity humidity
The humidifier is equipped with a humidity setting function in the range of 40% - 90% RH). To start the
process of setting the humidity level, use the button on the control panel and on the remote control.
Each press of the button changes the set point of the humidity level by 5 percentage points (40% - 45%
- 50% -… - 90%). Ambient humidity is measured with an accuracy of +/- 5%. When setting the humidity
level, information about the set value appears on the display. After a few seconds, the device will display
the current humidity level. The device will turn off automatically when the set humidity level is exceeded.
If the ambient humidity level is higher than the set value, the device will not start the humidification
process.
REMOTE CONTROL
III. OPERATING THE DEVICE
