EDO
EN
14
www.eberg.eu
Membrane cleaning brush
Always turn off the device and disconnect it from the power supply before cleaning. Do not touch the
water in the base! The small amount of water in the base of the device is a natural effect resulting from the
design and specification of the device.
Clean the water tank regularly with clean water and a soft, damp cloth. Do not use detergents, alcohol, or
other chemical and corrosive substances. Do not use hard brushes. Allow it to dry before restarting the
device. Do not install the nozzle column in the tank until these components are completely dry.
A special brush with a humidifier should be used to clean the steam-generating membrane. The membrane
is located under the descaling filter. The brush is located in a special place in the base of the humidifier.
•
The device is equipped with a descaling filter. It is located in the center of the humidifier base.
•
To replace the filter, lift the water tank by detaching it from the base of the humidifier. Perform this
operation with extreme caution and pay special attention not to spill the water from the tank or
replace the filter when the water tank is empty.
•
Pull the used filter out of the center of the humidifier base.
•
Put the new filter in the same place.
•
Place the water tank back in place.
Attention!
The device is originally equipped with one descaling filter. The replacement filter must be purchased
separately.
VI. CLEANING AND MAINTENANCE
Descaling filter
Descaling filter
