ELIO
EN
40
www.eberg.eu
Drainage hose
1
Note: All the illustrations in this manual are for explanatory purposes only. Your appliance may be slightly
different.
INSTALLATION INSTRUCTIONS
EXHAUSTING HOT AIR
When use the appliance in cool mode, the hot air exchange of
the condenser must be exhausted out of the room completely.
First position unit on a flat floor and make sure there’s
a minimum of 18”(45cm) clearance around the unit, and is
within the vicinity of a single circuit outlet power source.
1.
Extend either side of the hose (Fig.1), and screw the hose
inlet (Fig.2).
2.
Extend the other side of the hose and screw it to the hose
outlet (Fig.3).
3.
Install the hose inlet into the unit (Fig.4).
4.
Affix the hose outlet into the window slider kit and seal.
(Fig.5 &6) or window sealing - EBERG CLIMALOCK.
The window slider kit has been designed to fit most standard vertical and horizontal window applications,
however, it may be necessary for you to modify some aspects of the installation procedures for certain
types of windows. The window slider kit can be fastened with screws.
NOTE: If the window opening is less than the minimum length of the window slider kit, cut the end without
the hold in it short enough to fit in the window opening. Never cut out the hole in window slider kit.
