ELIO
EN
45
www.eberg.eu
SETTING THE TIMER
This timer can be used to delay the appliance start-up or shutdown, this avoids wasting
electricity by optimizing operating periods.
a) Programming start-up
•
Turn on the appliance, choose the mode you want, for example Dehumidify mode, high fan speed.
Turn off the appliance.
•
Press the “
“ button , the screen starts to flash, press the “
“ / “
“ to adjust the set time
from 0.5-24 hours.
•
In 5 seconds without the operation, the timer start function, then the “Timer” symbol lights.
•
Press the “
“ button again to cancel the Timer, and the “Timer” symbol disappear.
b) Programming shut down
•
When the appliance is running, press the “
” button, the screen starts to flash. - Press the “
“
/ “
“ to adjust the set time from 0.5-24 hours.
•
In 5 seconds without the operation, the timer start function, then the “ Timer” symbol lights.
•
Press the “
“ button again to cancel the Timer, and the “ Timer “ symbol disappear.
SWITCH THE UNIT OF TEMPERATURE
When the appliance is standby, hold on “
” and ” ” button together 3 seconds by the same time, then
you can change the unit of temperature.
SELF-DIAGNOSIS
The appliance has a self diagnosis system to identify a number of malfunctions. Error messages are
displayed on the appliance display.
IF IS DISPLAYED
WHAT SHOULD I DO?
PROBE FAILURE
(sensor damaged)
If this is displayed, contact your local authorize
service centre.
FULL TANK
(safety tank full)
Empty the internal safety tank, following the
instructions in the “End of season operations”
paragraph.
