24
25
Function Description
GB
This machine has a regular reminding function of filter replacement, which works
every 320 hours and 1500 hours. After every 320 hours, the indicator light on the
panel will flash to inform users to clean the filter No.1. After cleaning, press the
„reset” button for 5 seconds, then the light will stop flashing. After every 1500
hours, the indicator light will stay on to inform users to renew the filter No.2 and
No.3. At that time, press the button for 5 seconds so that the timing can be reset.
The second function of the „reset” button: When the machine is on, press this
button and the total working time will be shown in hours on the screen. This
equals a check of working time. Since the screen can only display three figures,
the thousands digit will be displayed first, then hundreds, tens and single. Please
read them together.
When the machine is on, it will turn to sleeping mode 5 seconds after the
„sleeping” button being pressed. In sleeping mode, all the lights turns off and
the machine works at the first gear. Press any button to wake it up and then press
„sleeping” button to quit sleeping mode, or press „wind speed” button or smart
button to quit after waking it up.
When the machine is on, touch „child-lock” button to lock all the buttons. At that
time all the buttons have no reaction to any touch, while the machine still works
how it is set before. Press „child-lock” button for 5 seconds and the machine will
quit this mode. (The icon will stay on when the machine operates in child-lock
mode, otherwise it will be off.)
When the machine is on, touch „SPEED -” or „SPEED +” to switch the gear and
change the operating speed. After the gear being changed, the motor will work
only at the setting level without being affected by the sensor.
In auto mode, the machine will turn to sleeping mode 2 minutes after the
surrounding light <5x. It will quit sleeping mode 3 minutes after the surrounding
light >5x, and then continue to work in auto mode.
Reset
Sleeping
Child-Lock
Light-sensitive
SPEED
SPEED
Function Description
GB
3. Powering Off
How to Use
If you press the power button on the operational panel while the machine is
running, the machine will enter into standby mode. (And the icon will turn red)
1. Auto mode.
When the machine is plugged in, press „power” button and „auto” button in sequence,
then it can operate under the control of intellisense. The motor’s operating gear will adjust
automatically to the PM2.5 data collected by the sensor. This mode is suitable for most situations.
2. Compulsory mode.
When the machine is plugged in, press „power” button. Press „wind speed”
button to choose the gear, and then choose to turn on or off the negative ion generator and the UV
germicidal lamp. This mode is suitable for the situations where compulsory purification is needed.
The machine cannot change the gear automatically in this mode.
3. Night mode.
In the two modes mentioned above, the machine will turn to work at the first
gear as long as „sleeping” button is touched, making sure there is no noise affecting your rest.
(In auto mode, it will turn to sleeping mode when the environment becomes dark, sensed by the
photosensitive sensor)
4. Timing mode.
In the three modes mentioned above, after „timing” button being pressed and
operating time being set, the machine will start to count down. The machine will stop working after
the countdown is finished. (If you need to cancel the countdown, please press the button until the
time displayed is accumulated to 12 hours, then one more touch will cancel this mode)
5. Child-proof lock mode.
In the four modes mentioned above, the machine will turn to child-proof
lock mode after „child-proof lock” button is pressed. Any operation through the panel or the remote
control will be invalid before quitting this mode. (It can be quitted by pressing „child-proof lock”
button for 3 seconds or the unlock button on the remote control.)
Power
