ERI
EN
14
www.eberg.eu
•
Warning! In order to avoid overheating, do not cover the heater. Do not place objects on the product
or allow objects to obstruct the inlet or outlet openings.
•
Do not leave the device unattended when it is switched on. This also applies to remote control or a
mobile application using.
•
Warning! If the heating panel is splashed with water or immersed, disconnect the device immediately
by removing the plug from the power socket.
•
Warning! Make sure your hands are dry when you touch the device. Do not touch the device, plug or
cord witch wet hands, otherwise there is an electric shock and risk of injury to life or health.
•
Save these instructions.
2. UNPACKING AND WALL MOUNTING INSTRUCTIONS
Before use, carefully check the contents of the kit. Take the heating panel out of its packing and make sure
that the devices is in good condition. Do not start the device with a damaged cable or housing. Before
commissioning, make sure that the mains voltage parameters are consistent with the data given on the
rating plate of the device.
Before installation, make sure the distance between the bottom of the heater and the floor is no less than
20cm.
1. Mark the positions of the four holes to be drilled
on the wall. Better install the heater 20cm to
100cm above the floor to get best performance.
2. Drill the holes with the drill bit from the
accessories pack.
3. Insert the plastic rails fitting into the holes.
4. Install the panel heater onto the four rails
fittings matching the four holes in the heater.
