8
9
EN
Q2
Follow the safety instructions to avoid any danger.
•
Installation must be performed by a service technician or a similarly qualified person in order to
avoid a hazard.
•
Important! Make sure that there are no electric cables or other installations (e.g. water pipes) in the
vicinity of the drill holes. Make sure the unit is secured to the wall securely and in a vertical position.
Make two holes in the wall 2 m above the floor, not closer than 0.25 m from the corners (Fig. 1). The holes
should be separated by 320mm in the horizontal plane. Remember that the diameter of the hole is the
same as the diameter of the pins. Fix two bolts in the studs, the bolt heads should protrude by 10mm (Fig.
2). Hang the device on the hauling screws after they are properly adjusted (Fig. 3).
•
Before connecting the plug to a power socket, make sure that the power supply matches the voltage
on the rating plate on the device.
•
Carefully remove the air curtain from the box and then from the plastic bag.
•
Place the product on a firmly leveled surface, make sure that the main switch is in the „-” position.
Connect the cord to the AC220-240V electrical outlet. The device beeps, and the power light comes
on.
Fig. 1
Fig. 2
Fig. 3
DEVICE INSTALLATION
3. INSTRUCTIONS FOR USE
