ROT
EN
17
www.eberg.eu
3. OPERATING INSTRUCTIONS
1. Check the heater to be sure it is not damaged.
2. Insert the plug in the socket.
3. Press the button: the heater will start working. The display will show the room temperature.
4. After use, press the button first in order to switch the device off. Finally remove the plug from the socket.
Thermostat:
•
If you press the (+) or (-) key, the temperature setting will flash 5x on the display.
•
You can adjust the temperature setting by pressing the (+) or (-) key while it is flashing. With each key
press, the temperature will be increased (+) or decreased (-) by one degree.
Timer:
•
Briefly pressing once on the M button will switch the timer on.
•
You can set the time when the heater is to switch itself off by pressing the (+) or (-) buttons: with each
press it will go an hour forwards or backwards.
•
The timer time is set after 5x unchanged blinking. The display will now alternately show the room
temperature and the set number of hours.
•
The heater will switch itself off after the set number of hours.
4. CONFIGURATION OF CONNECTION WITH WI-FI WIRELESS NETWORK AND
MOBILE APPLICATION
In order to be able to remotely control a configured device using the mobile application, it must remain
connected to the power network, be turned on, be witthin the range of the Wi-Fi network saved in its
memory (with the name SSID and password set during configuration), this network must access the
internet and ports may not be blocked.
The operation of the device can only be controlled by one mobile application at a time. If you want to
change the phone from which the device is operated, uninstall the device in the application on that phone
and configure the connection with the new phone as described in the manual.
