57
ED-3 SP Pedelec with Lithium-ion battery
GB
The flashing numbers can be altered by pressing
the arrow button “/’d3. Navigate one step further
by pressing the arrow button “
” d3, alterations
start with the hours and progress to minutes,
etc.
Once the correct time has been entered, press
the EXIT button to reach the “SAVE / CANCEL
Mode”.
PIN
A PIN number can be entered in order to
individually protect your bicycle. The Pedelec
can only be used after the correct PIN number
has been entered. Please make a note of your
exact PIN number as activation of a forgotten
PIN can only be carried out through the Service
Centre.
The editing mode of the PIN can be entered
from the SETUP•IN display, by pressing the
“ENTER” button. The individual numbers of the
PIN to be edited will flash respectively. All other
PIN figures are blocked out by a “-“ display. The
PIN’s factory setting is “0000”.
The first position flashes, starting with 0.
Navigate one step further to the right by using
the arrow buttons. After entering the currently
activated PIN (old), a command is given to enter
the new PIN (new). Before the new PIN can be
finally adopted, it must be re-entered (rpt) for
safety reasons.
Entering the new PIN
