20/28
Item no.: 601.2055 · ENU · Change V1.1 · Release 2022-10-11
Drive concepts
Drive concepts
SIMATIC MICRO-DRIVE
SIMATIC MICRO-DRIVE
Installation
5 Installation
DANGER
Dangerous movements
Check the electrical equipment of the drive at regular intervals.
→
Ensure there are sufficient protective fixtures in the devices/systems, as actuating the drives in the wrong
way can lead to dangerous movements.
Possible remedial actions include:
→
No lingering within the movement area of the devices or systems.
→
Ensuring that the stability of the (protection) covers and housing is sufficient enough to resist the maximum
movement or rotation energy.
→
Before opening the drives or entering the danger zone, ensure all connected drives are safely brought to a
standstill, are de-energized, and are secured against switching on again.
WARNING
Impermissibly high load
Do not make any changes to the drive
→
Subjecting the drive to impermissible loads (e.g. impact, heat, overvoltage, mechanical load) might damage
it. In this case, decommission the product immediately and, before recommissioning it, check that it is in
proper condition.
WARNING
Electromagnetic radiation
When integrating the drive into the system, the interaction may cause interference in terms of electromagnetic
compatibility (EMC). Ensure that the entire system is electromagnetically compatible.
WARNING
Health hazards for persons with pacemakers, metal implants, and hearing aids
For these people, access to the following areas is prohibited:
→
Areas in which electrical devices and parts are assembled, operated, or put into operation.
→
Areas in which motor parts with permanent magnets are stored, repaired, or assembled.
WARNING
Depending on the installation and operating conditions, the sound pressure level may exceed 70 dB(A)
Risk of noise-induced hearing loss
→
Take appropriate technical safety measures.
→
Protect operating personnel with appropriate safety equipment such as hearing protection.
CAUTION
Hot surface – risk of burns
→
Ensure sufficient protection against accidental contact.
→
Ensure there is sufficient cooling.
CAUTION
Risk of cutting and crushing hazard when removing drive from packaging and when assembling
Carefully remove the drive from packaging, touching only the housing. Never subject to any impacts!
→
Wear safety shoes and cut-resistant safety gloves.
