Operating instructions
W3G300-ME46-01
Translation of the original operating instructions
3.2 Nominal data
Motor
M3G084-BF
Nominal voltage / VDC
26
Nominal voltage
range / VDC
16 .. 32
Method of obtaining
data
fa
Speed (rpm) / min
-1
3000
Power consumption / W
175
Current draw / A
6.7
Min. ambient
temperature / °C
-40
Max. ambient
temperature / °C
85
ml = Max. load · me = Max. efficiency · fa = Free air
cs = Customer specification · ce = Customer equipment
Subject to change
3.3 Technical description
Weight
2 kg
Size
300 mm
Motor size
84
Blade material
PA plastic
Fan housing material
PP plastic
Number of blades
7
Airflow direction
V
Direction of rotation
Clockwise, viewed toward rotor
Degree of protection
Motor IP24 KM, electronics IP6K9K
(mating connector installed)
Insulation class
"B"
Moisture (F) /
Environmental (H)
protection class
H4
Ambient temperature
note
Occasional start-up at temperatures
between -40°C and -25°C is permitted.
For continuous operation at ambient
temperatures below -25°C (such as
refrigeration applications), use must be
made of a fan design with special low-
temperature bearings.
Installation position
Any
Mode
S1
Motor bearing
Ball bearing; (sealed)
Life expectancy
40,000 h (depending on load profile and
ambient conditions)
Technical features
- Locked-rotor detection
- Error output (high-side switch)
- Power limiter
- Load dump protection
- Motor current limitation
- Soft start
- Control input 0-10 VDC / PWM
- Temperature derating
- Thermal overload protection for
electronics
- Reverse polarity protection
Electrical hookup
Plug; Standby current less than 500 µA
Protection class
assignment
0; Built-in component with basic
insulation, protection class is based on
the intended installation.
This component for installation may
have several local protection classes.
This information relates to this
component’s basic design.
The final protection class is based on
the component’s intended installation and
connection.
Approval
EAC; E1
Comment
Type approval number - 069401
;
Use the device in accordance with its degree of protection.
Information on surface quality
The surfaces of the products conform to the generally applicable industrial
standard. The surface quality may change during the production period.
This has no effect on strength, dimensional stability and dimensional
accuracy.
The color pigments in the paints used perceptibly react to UV light over
the course of time. The product is to be protected against UV radiation to
prevent the formation of patches and fading. Changes in color are not a
reason for complaint and are not covered by the warranty. UV radiation
in the frequency range and the intensity of natural solar radiation has no
effect on the technical properties of the products.
3.4 Mounting data
Further mounting data can be taken from the product drawing or Chapter
4.1 Mechanical connection as required.
Strength class of
screws
8.8
For screw clearance, see Chapter 3.1 Product drawing
;
Secure the screws against unintentional loosening (e.g. use self-
locking screws).
3.5 Transport and storage conditions
Max. permitted
ambient temp. for
motor (transport/
storage)
+85 °C
Min. permitted
ambient temp. for
motor (transport/
storage)
-40 °C
Item no. 57879-5-9970 · ENU · Change 262216 · Approved 2022-09-19 · Page 5 / 10
ebm-papst Mulfingen GmbH & Co. KG · Bachmühle 2 · D-74673 Mulfingen · Phone +49 (0) 7938 81-0 · Fax +49 (0) 7938 81-110 · info1@de.ebmpapst.com · www.ebmpapst.com
