User Manual VW 1350 HB
– The Manual Operated VMS-Trailer
3.3 INSTALLATION AND INSPECTION OF THE
MACHINE
3.3.1 BEFORE USING THE MACHINE
Before using the EBO van Weel B.V. machine, please check the
following points:
1. tire/ tire pressure:
before the machine will be transported, it is
required to check the tire pressure. You can find the correct tire
pressure on the mudguard of the machine.
2. lighting:
please check the lighting in operation before you will
transport the machine.
3. batteries:
check the power of the batteries before using the
machine. A sufficient battery voltage is 24,6 volt or higher.
4. functions:
check the hydraulic functions and the operation of the
display before use.
5. visual inspection:
note any defects, leaks or defective parts on
the machine. Where necessary, inform EBO van Weel B.V. if
you have any doubts about the machine.
6. solar panels:
keep the solar panels clean for the highest possible
efficiency.
3.3.2 CLEANING THE MACHINE
Winter:
Remove ice and snow before operation in winter. Check the hinges
holding the upper panel and the adjustment drive for proper movability.
We recommend cleaning by hand using commercial automobile care
products. Do not use steam or high-pressure equipment.
3.4 CONTROLS
This chapter explains where the controls of the machine are located to
operate the machine in a proper manner.
3.4.1 CONTROLS
Front compartment
In order to make the machine ready for use, please switch the main
power
button to ‘’ON’’. This button is also the cut-off switch if the user is
in an unsafe situation. The switch is mounted on the main casing, see
figure 2.
The battery charger is positioned on the left side of the front
compartment, see figure 3.
For selecting an animation which will be projected on the display, a page
selector (optional) is required. The selector is attached on the left side
of the main cabinet. The operation is explained in section 4.2.3.
