March 2013 IPV38 / IPV38WE
63
Once an alarm has occurred, there will be indication as below:
1.
The corresponding status light turns Red and keeps blinking.
Figure 10.7
2. If you set
Sound on Alarm
, you can hear a beep sound from your computer you use when alarmed.
(Figure 10.6).
3. If you set
Record on Alarm,
the camera will record automatically for approx one minute. You can find
the record file in the folder which you set. (Figure 10.9).
4. If you set
Send Mail on Alarm
, you will receive e-mail alarm alert once motion is detected. (Figure
10.0).
5. You can also set
Scheduler
to enable the camera to send e-mails during a special time range you want.
(Figure 10.5).
6. If you set
Upload Image on Alarm
, it will upload images to the FTP Server you set already, once
alarmed. (Figure 10.4).
NOTE
: Each alarm only lasts for approx one minute, all the above functions for motion detection
triggered only.
REC Automatically and Save to PC
When you enable motion detect and open the camera monitoring page on the PC, if there is an alarm
triggered, REC will start automatically for several seconds and save to the PC.
New Feature
: Start the motion detection compensation and Alarm notification by Http.
3.14 Path Settings
Figure 10.8
Here you can set record path and alarm record path for the camera.
Figure 10.9
Record Path:
Here you can set the manually record path. Click
then start manual recording,
the record file will be saved to the specified path you set here.
Alarm Record Path
: Here you can set the alarm record path. When motion is detected, and record
enabled, it will start alarm record automatically, the record file will be saved to the specified path you set
here.
