background image

14-7-2010                                                                          

3

                                                                033000=13069E 

User Guide  

CONTENTS 

1. CONFORMATY OF USE 
2. INTRODUCTION  
3. SET CONTENTS 
4. TRANSMISSION OF YOUR ORIGINAL REMOTE CONTROL SIGNALS 
5. INSTALLING THE SYSTEM 
6. EXPANDING THE SYSTEM 
7. TROUBLESHOOTING 

1.

 

Conformity of Use 

For carefree and safe use of this product, please read this manual and safety information 
carefully and follow the instructions. The unit is registered as a device that does not cause 
or  suffer  from  radio-frequency  interference.  It  is  CE  approved  and  it  conforms  with  the 
Low  Voltage  Directory.  The  safety  and  installation  instructions  must  be  observed. 
Technical manipulation of the product or any changes to the product are forbidden, due 
to security and approval issues. Please take care to set up the device correctly - consult 
your  user  guide.  Young  children  should  use  the  device  only under  adult  supervision.  No 
guarantee or liability will be accepted for any damage caused due to incorrect use of 
the equipment supplied, other than indicated in this owner’s manual. 

SAFETY WARNINGS 

To  prevent  short  circuits,  this  product  (except  if  specified  for  outdoor  usage)  should 
only be used inside and only in dry spaces. Do not expose the components to rain or 
humidity.  

Only connect the adapter to the mains after checking whether the mains voltage is 
the same as the values on the rating labels. Never connect an adapter or power cord 
when  it  is  damaged.  In  that  case,  contact  your  supplier.  If  there  is  any  danger  of  a 
thunderstorm,  it  is  a  good  precaution  to  unplug  the  power  supply  from  the  mains 
network in order to protect it from lightning. The same applies if the system is to be out 
of action for any length of time. 

Avoid  strong  mechanical  tear  and  wear,  extreme  ambient  temperatures,  strong 
vibrations and atmospheric humidity. 

Do  not  disassemble  any  part  of  the  product:  the  device  contains  live  parts  and  no 
user-serviceable parts are inside. The product should only be repaired or serviced by 
qualified  and  authorized  service  personnel.  Defected  pieces  must  be  replaced  by 
original (spare) parts. 

Batteries:

 keep batteries out of the reach of children. Dispose of batteries as chemical 

waste.  Never  use  old  and  new  batteries  or  different  types  of  batteries  together. 
Remove the batteries when you are not using the system for a longer period of time. 
When inserting batteries be sure the polarity is respected. Make sure that the batteries 
are not short circuited and are not disposed in fire (danger of explosion). 

In  case  of  improper  usage  or  if  you  have  opened,  altered  and  repaired  the  product 
yourself, all guarantees expire. The supplier does not accept responsibility in the case of 
improper  usage  of  the  product  or  when  the  product  is  used  for  purposes  other  than 
specified.  The  supplier  does  not  accept  responsibility  for  additional  damage  other  than 
covered by the legal product responsibility. 

Summary of Contents for PowerMid Classic










Reviews: