18-5-2011 10 033000=15301
A
4.8 The FAV key
The
FAV
key allows you to program two specific channels and switch
between them with a single key-press. The two channels can be up to 4
key-presses each and must be a minimum of 2. The first keypress must be a
Mode key e.g. TV with the following keys being up to 3 digits. To program
the FAV key :-
a. Press and hold the
S
(8) button until the LED remains on (occurring after
approximately 2-3 seconds).
b. Release
S
(8) button.
c. Press and release the
FAV
(10) key.
d. Press and release desired
Mode
(4) key (e.g. TV) followed by the 1, 2 or 3
digit keys in the correct order for the first channel selection. The LED will flash
for each keypress.
e. Press and release the
FAV
(10) key.
f. Repeat Step "d" for the second device channel selection.
g. Press and release the
FAV
(10) key to store the channel selections. The LED
will turn off and remote returns to normal.
To select between the two channels, press and release the
FAV
key.
4.9 ebode / X10 Home Automation Control
The TAKE 6 remote control allows you to command all electric appliances
you have in your house. Here are some examples that you can do with your
TAKE 6 remote using ebode/X10 home automation modules:
• Dim the lights and switch them on and off while watching TV.
• Turn the coffee machine on from your bedroom when you wake up in the
morning.
• Turn your lights on at night to scare off intruders when you hear noises.
• Switch on your electric blanket before the movie ends, so you can enjoy a
warm bed once the movie is finished.
• Switch everything off with a single press of a button when you go to bed.
ebode / X10 Home Automation: control all electrical appliances with one
remote control
The TAKE 6 Remote has two transmitters: an infrared (IR) transmitter and a
radio frequency (RF) transmitter. This allows you to operate practically
anything. You can operate your TV, video etc. with the infrared (IR)
technology. The ebode / X10 radio frequency (RF) technology makes it
possible to operate lights and appliances from anywhere in the home.
To control your lights and appliances, you need an IR7203 or ebode / X10
Transceiver module and some ebode / X10 Home Automation Modules,
which can simply be plugged in the socket. Extra wires are not necessary.
Use a Transceiver Module (available separately) and connect your table
lamp or other electrical appliance. Switch on/off: control everything with the
TAKE 6. The Transceiver Module converts the RF signals of the TAKE 6 into an
ebode / X10 signal that is transferred via the mains power line. All other
ebode / X10 modules that are connected to your mains, are also operate
able through the TAKE 6 Remote. Ask your dealer for more information.
You can control the ebode / X10 Home Automation Modules as follows:
1. Press the ebode / X10 home automation
button .
2. Use the numerical keys to select the Unit Code of the Module of your
choice (1-digit codes do not have to preceded by a ‘0’).
3. Press the button of the function you want to execute (see overview
below).
ebode / X10 Home Automation functions:
On: C
Off: CHANNEL -
Brighter:
Dim: VOLUME -
All lights on: Power
All units off: Mute
