18-5-2011 4 033000=15301
A
b) Program your TAKE 6
1. Turn on the equipment that you wish to control ( TV, DVR, DVD, STB, AUX/
, AUDIO). Please note that with the TAKE 6 you can either select to
control an appliance or
, not a combination of these two.
2. The AUX key allows you to program and control any equipment such as
TV, DVR, DVD, CD, STB,
.
3. Take the code book supplied with the TAKE 6 and find the brand of the
equipment you wish to control. E.g. if you have a Thomson TV look for
Thomson under the TV section.
4. Press and hold on the key marked "
S
" (8) until the LED (2) stays
permanently on. This takes about 3 seconds. Release the "
S
key".
5. Press and release the TV, DVR, DVD, STB, AUX, AUDIO, mode key (4), in
accordance with the appliance you wish to control.
6. From the code book take the first number corresponding to your
equipment and enter the number by pressing the 0-9 key pad (14). Each
time you press a key the LED (2) will flash.
7. If the number is correctly entered the LED will turn off. If the number is
incorrect then the red LED will flash fast. If incorrect you will need to restart at
4.
Press the
POWER
key (1)
.
If your equipment switches off you have found the
right code. If it does not switch off, you will need to restart from 4.
Sometimes there are several codes that have similar features. If you find that
your TAKE 6 does not work for some functions, you may need to try another
code.
1. Introduction
The TAKE 6 is designed to control up to 6 devices: TV, DVR, DVD, STB, AUDIO
or any other device under AUX mode key (Please note that you can either
select to control an appliance or
, not a combination of these two.).
The TAKE 6 contains a library of codes that are preprogrammed into the
remote control. This library covers nearly all the audio video products on the
market today. The codes have to be programmed once before use. This
can be done in different ways:
a. Manual entry of one of the codes displayed under the related brand and
type of equipment in the attached code book (see 4.1)
b. Automatic code search for some well-known brands (4.2)
c. Automatic code search for all brands (4.3)
d. Manual search through all codes (4.4)
2. Insert the batteries (always use NEW CR2032 batteries)
1. Open the cover on the back of the TAKE 6 Remote.
2. Insert 2 CR2032 batteries, verify that they are placed correctly with the +
on the battery in the same position as marked inside the battery
compartment.
3. Close the battery compartment carefully.
3. Function of the remote’s buttons
[1] POWER (On/Off)
Allows you to switch off the last selected appliance. Some appliances can
also be switched on with this button.
