18-5-2011 6 033000=15301
A
PAUSE
In DVR, DVD or CD mode:
This button works the same way as in your original
remote.
IN TV mode:
Coloured key (Magenta), control of fasttext or special
equipment functions.
[16] A/V
Selection of an external source (e.g. SCART input).
[17] INFO
Displays on screen information of the selected appliance (when
available).
[18] Teletext
Teletext OFF: Stop Teletext / Fasttext.
[19] Teletext
Teletext Hold: Stop page change in Teletext / Fasttext mode.
[20] LEARN
Programming button for learning the functions of your original remote
control.
See chapter 4.5, Learning codes, for information about programming these
codes.
[21] Teletext
Teletext ON: Start/stop Teletext / Fasttext.
4. Programming
To make your remote suitable for your own equipment, you have to program
it once. You can do this by entering a code, related to the brand and type
of equipment you want to control. You can program any equipment under
any MODE key. For example, if you have three videorecorders, you can
program videorecorder 1 under DVR, videorecorder 2 under AUX and
videorecorder 3 under AUDIO.
4.1. Manual code entry
Take your code book and search for the list matching the equipment you
are looking for, e.g. TV or DVR. Next, find the relevant brand (e.g. Sony). Now
you will find one or more 4-digit codes. If there is more than one code, it
depends on your equipment which code is correct. Generally, the codes
are displayed in order of age of the equipment. Older equipment first,
younger equipment at the end. Sometimes you will have to try several codes
before you find the right code for your equipment.
1. Make sure your equipment is switched on (for example TV).
2. Press and hold the
S
(8) key until the LED indicator lights continuously.
Release the
S
key.
3. Press and release the mode key (4) of the device you want to control (for
example TV).
4. Enter the 4-digit code from the Code Book by using the key pad (14). The
LED (2) turns off after the last digit is entered. If you entered a wrong code
the LED blinks for 3 seconds and then goes off. You have to repeat from step
2.
5. Point the remote in the direction of your TV and press the
POWER
button
(1). Your device should turn off. Check other functions (for example for a
DVR FF or REW, etc.). If certain functions are not responding, this indicates
that the entered code is not the correct one. In that case repeat the above
procedure with the next corresponding code of your brand.
6. Repeat this procedure from step 1 for the other equipment you want to
control (DVR, DVD, STB,...). If your equipment (TV, STB, etc....) does not
respond, try the other codes for your brand. If it still doesn’t respond, try the
manual code search method (4.4 Manual code search).
4.2. Automatic code search for some well-known brands
If your brand is listed hereafter, you can use the brand search method (faster
than the "manual" and the "automatic code search").
