18-5-2011 9 033000=15301
A
b. Press the button on the existing remote control you want to learn.
Keep this button pressed as long as you would when using the
original remote control.
7. Repeat steps 5 and 6 for every button you want to learn.
8. When you have finished learning the buttons, press SETUP (8)
Erasing the commands learned per mode to clear memory space
You can erase the commands learned and saved for each separate
function (TV, VCR, etc.):
1. Keep the SETUP (8) button pressed until the LED stays lit. Release the SETUP
(8) button.
2. Press the Mode button of your choice (TV, DVR, etc.). The LED will flash
once.
3. Press the LEARN (20) button twice.
4. Press SETUP (8). The LED will extinguish after a few seconds.
5. All commands learned and saved for the selected function have now
been erased.
4.6. Identifying codes found
If you don’t know the code (for example because you found the code by
autosearch) you can identify it as described below:
1. Press and hold
S
(8) until the LED indicator (2) lights steadily. Release
S
.
2. Press the mode key (4) for the equipment you want to identify (DVR, DVD,
STB, AUDIO or AUX). The LED blinks once.
3. Press again
S
. The LED blinks once.
4. To identify the first digit press each number button from
0 - 9
(14) until the
LED blinks. The number you pressed is the first digit of the code.
5. Press each number key from
0 - 9
as above to find the second digit.
6. Press each number key from
0 - 9
as above to find the third digit.
7. Press each number key from
0 - 9
as above to find the fourth digit. When
the fourth digit has been found the LED will go off.
4.7 Volume Control Punch Through
The TAKE 6 remote control allows you to select which Mode controls your
volume/mute buttons. The
volume buttons (5)
and Mute (3) can be set for
individual control by EACH device Mode or can be set for ALL device Modes
to punch-through volume control to one specific single device Mode. The
remote is initially set (Factory Default) for control by each specific device
Mode.
Adjustment of ALL volume controls to one mode.
You can allocate volume control to one of the modes of the remote control
providing that volume control exists on the corresponding device (e.g.
control of TV sound in DVR, DVD, etc... mode).
- Hold down the
S
(8) key until the LED remains lit.
- Release the
S
(8) key.
- Press and hold the MUTE (3) key until the LED flashes once, then release the
MUTE key.
- Press the required mode key, e.g. TV, corresponding to the device that will
control the VOL and MUTE buttons for ALL the device Modes.
- Press and release the MUTE (3) key and the LED turns off.
Adjustment of the volume controls for EACH mode.
You can allocate volume control to be individual for each mode selected,
providing that volume control exists on the corresponding device (e.g.
control of the television set sound in TV mode, the control of the sound of the
STB receiver in STB mode, ...).
- Hold down the
S
(8) key until the LED remains lit.
- Release the
S
(8) key.
- Press and hold the MUTE (3) key until the LED flashes once, then release the
MUTE key.
- Press the required mode key, e.g. DVD, corresponding to the device that
will control its own VOL and MUTE keys.
- Press and release the
VOL - (5)
key once.
- Press and release the MUTE (3) key once and the LED turns off.
