Digital Reader Program Instructions
Section (1a) Programming
Several functions of the digital display are user programmable. The following instructions
describe what features are available and how to change the system’s defaults to customize the
display for a particular application.
The Keys pictured have multiple functions. Timing, which is how long a key, is depressed, and
the combination of the keys pressed is important. This manual uses the term “
momentarily
”
to describe a key press of typically less then 1 second. Whereas “
press and hold
” is used to
imply a key press of typically longer then 1.5 seconds. As an example when using a PC
keyboard to type a CAPITAL letter you would “
press and hold
” the SHIFT key and
“
momentarily
” depress the appropriate letter key.
The “
function
” associated with the key(s) pressed is executed on the key RELEASE, not the
key DEPRESS. This is important since some keys execute different functions based on how
long they are depressed. These key operations, once tried, quickly become intuitive.
ON/OFF
MODE
+
0
-
To enter programming mode,
press and hold
the MODE and then
momentarily
press the 0
(zero) key. The MODE key must be held for approximately 1 second before the depression of
the 0 (zero) key.
Once you are in the Programming Mode,
momentarily
pressing the MODE key will advance
through the Programming Parameter list.
To step backwards in the Programming Parameter list
press and hold
the ON/OFF key and
momentarily
press the MODE key.
Momentarily
pressing the + (plus) key while displaying a Programming Parameter will increase
the parameter setting.
Momentarily
pressing the – (minus) key while displaying a Programming Parameter will
decrease the parameter setting.
Momentarily
pressing the 0 (zero) key while displaying a Programming Parameter will revert
the parameter to its factory default setting.
REV A 12-2-05 19
