WHEEL BEARINGS
The wheel bearings are sealed units. No greasing or
maintenance is required.
Inspect wheel bearings each time the wheel is removed.
Replace when worn.
NOTE:
Excessive play or roughness indicates worn
bearings that require replacement.
VOLTAGE REGULATOR
The alternator output is controlled and changed to direct
current by the voltage regulator.
The voltage regulator increases charging rate when
battery voltage is low.
The voltage regulator decreases charging rate when
battery charge is up.
It is possible to overload your motorcycles charging
system by adding too many electrical accessories . If
your combined electrical accessories operating at any
one time consume more electrical current than your
vehicle’s charging system can produce, the electrical
consumption can discharge the battery and cause
vehicle electrical system damage. See an EBR dealer
for advice about the amount of current consumed by
additional electrical accessories, or for necessary wir-
ing changes.
NOTE
The voltage regulator does not require any scheduled
maintenance. If any electrical system trouble is experi-
enced that might be traceable to the alternator or volt-
age regulator, take the motorcycle to an EBR dealer.
Dealers have the necessary parts and testing equipment
to perform electrical service.
NOTE:
Use Nickel based anti-seize on all bolts that
are being installed in front and rear wheels
135
Summary of Contents for EBR 1190RS 2013
