CPX230NWB ALARM CONTROL UNIT – USER MANUAL
17 / 42
EN
In order to arm the system in fully armed mode, enter one of the following sequences:
1.
Arming all partitions:
<user code> or
<user code> or
<user code>
<-here, the system will be armed in full mode in two cases:
a)
If perimeter output lines are assigned and they are triggered during the
exit time countdown.
b)
If no perimeter output lines are assigned.
2.
Arming only the first partition P1:
<user code>
3.
Arming only the second partition P2:
<user code>
When the correct code is entered the keypad will generate a triple tone and then the
system will be armed at once or after the exit time passes.
7.4.1.2.
Sleep mode
Arming partitions in sleep mode is sensible when the partition has at least one night line
assigned (whether switched off during the night or delayed). In order to arm a partition
in sleep mode, enter one of the following sequences:
1.
Arming all partitions:
<user code>
or
<user code>
2.
Arming only the first partition P1:
<user code>
3.
Arming only the second partition P2:
<user code>
7.4.1.3.
Stay mode
Arming partitions in stay mode is possible only when they have perimeter lines assigned.
If not, the system will reject arming attempts, which will be indicated by the keypad with
a continuous, several seconds-long sound.
The system ill be armed in stay mode when one of the following sequences is entered:
press
, to delete previously entered data, and then re-enter the
correct code.