CPX230NWB ALARM CONTROL UNIT – USER MANUAL
28 / 42
EN
9.4.
CURRENT INPUT STATUS
If the user notices that diodes D and/or 4 below the indicator
are switched off, then
the function showing the actual status of inputs can be used to see which detectors are
triggered or sabotaged.
– Showing the actual status of inputs
Blinking of diodes belonging to a group means that it is currently being shown.
Continuously lit diodes of other groups mean that detectors assigned to them have been
triggered or sabotaged. Diodes switched off mean that no detector in the group has been
triggered or sabotaged. Switch between groups using the
button. Pressing
exits the function.
9.5.
FUNCTION CHIME
The function “Chime” allows to inform the person in the room about violation of the input
zones (e.g. opening or closing the entrance door). When the system is disarmed and
'chime zone' is violated, all wired keypads make a beep sound. No report is sent to the
monitoring station. It can be enabled/disabled by enter:
< Administrator code >
Blinking of diode belonging to a group (from A to D) means that it is currently being
shown. To enable/disable the chime for the selected line, press the appropriated key
(numbers from 1 to 8). Enable this function will be signalled by the lit chosen number,
disable by switched off diode. Switch between groups using the
button. Pressing
exits the function.
Time of saving parameters depends on the number of lines that have been changed. More
changes means longer save.
9.6.
ADDING NEW USERS
The function adds the code of a new user. The code can only be added by the
administrator. Default administrator code: 1111.
Note: The individual code must not be identical. If one
code duplicates another or is a code under duress by
another user (the last digit of the code increases, i.e. for
the code 2345, for example, a code under duress is 2346),
it will not be saved, which the keypad will indicate with a
continuous, several-second sound.
To add a new user:
1.
Enter the function
<administrator code>
. A correctly entered
code will be confirmed with a triple tone.
