CPX230NWB ALARM CONTROL PANEL – INSTALLER MANUAL
30 / 144
EN
4.1.
ACTIVATION OF SERVICE MODE
To activate the service mode the installer code authorization is required.
<Installer code>
3 beeps will confirm the correct input of the code and function number. PROG LED on will
inform that currently, the user is in service mode. When any service function is entered,
PROG LED will be blinking. After exit from the function, PROG LED will be lit constantly
again, informing that the user is in the main service mode menu.
4.2.
EXIT FROM SERVICE MODE
To exit the service mode press
and confirm with
. Using that function will trigger
the control panel’s reset using configured parameters.
The device will exit test mode automatically after 5 minutes without pressing the buttons
and system will restart.
4.3.
INSTALLER MENU
After enter the service mode You get permission to configure alarm central. By this
commands You can get into some menu sections (more information about procedures You
will get in chapters bellow):
Installer code change
Power loss time report
Number entered
LEDs on
0
1 2 3 4 5 6 7 8
1
1
2 3 4 5 6 7 8
2
1
2
3 4 5 6 7 8
3
1 2
3
4 5 6 7 8
4
1 2 3
4
5 6 7 8
5
1 2 3 4
5
6 7 8
6
1 2 3 4 5
6
7 8
7
1 2 3 4 5 6
7
8
8
1 2 3 4 5 6 7
8
9
1
2 3 4 5 6 7
8
10
1
2
3 4 5 6 7
8
11
1
2
3
4 5 6 7
8
12
1
2 3
4
5 6 7
8
13
1
2 3
4
5
6 7
8
14
1
2 3
4
5
6
7
8
15
1
2 3
4
5 6
7 8