4
5
The LED intensity dynamically indicates the
amount of compression during play.
– This switch actives
the filter section described under point 6.
- The filter section contains four
enhanced performance filters:
is a 'shelving' type 12dB/oct slope phase
compensated bass filter with a wide gain range.
is a shelving type filter controlling
the higher mids and treble registers, giving
presence and ambience to the sound.
is an advanced high pass filter capable
of producing bright high treble timbre, without
adding practically any noise.
FILTER ACTIVE
FILTERS
BASS
MIDDLE
TREBLE
BRIGHT
has an extended frequency range of
100-6000 Hz. This filter facilitates total control
over the mids, with a wide bandwidth giving a
natural and non-peaking result using frequency
dependent gain. In addition, at minimum setting
this filter facilitates a notch function, suitable for
cutting an exact frequency or eliminating
acoustic coupling.
5
6
Bass
Midrange
Treble
FRONT PANEL CONTROLS
1
3
4
5
6
8
7
2
F
UNCTIONAL
D
ESCRIPTION
F
RONT
P
ANEL
C
ONTROLS
:
INPUT
CHARACTER FILTER
- A low noise, high impedance
instrument input that will interface with passive
and active instruments perfectly.
- The EBS Reidmar
provides a preshape filter,
, which
operate independently from the other preamp
functions. This gives the user the opportunity to
preshape the sound before the final processing
with the other features of the preamp.
When pressed to inner position,
boost is
achieved in bass and treble ranges respectively,
while the midrange has a slight drop in gain.
Character
1
3
GAIN
COMP/LIMIT
- Control to adjust the instruments' signal
strength to the right operating level in the EBS
Reidmar.
For optimum basic signal level, turn up the
GAIN knob until the PEAK led starts flashing
from the strongest signal from the instrument.
- A low noise compressor
limiter that works fast and effectively, tightening
up the sound and preventing the bass head from
saturating at peaks when approaching the
headroom limit. A string may be plucked very
hard and fast, without any greater difference in
level or side effects.
The COMP/LIMIT knob sets the compression
ratio, i.e. The signal strength relation between
the input and output; the higher ratio the more
compression.
Note: A correctly set GAIN is vital for the
signal processing to work properly in the
.
EBS
Reidmar
à
2
4
Character ON
FUNCTIONAL DESCRIPTION
