Chengdu Ebyte Electronic Technology Co., Ltd.
E103-W01 User Manual
Copyright ©2012–2018
Chengdu Ebyte Electronic Technology Co., Ltd.
24
Response
：
• When succeed
，
return
+SYSGPIOREAD:<pin>,<dir>,<level>
OK
• if IO
pins are not in GPIO mode
，
it reminds
NOT GPIO MODE
！
ERROR
• <pin>
：
GPIO No.
• <dir>
：
‣ 0
：
set GPIO as input
‣ 1
：
set GPIO as output
• <level>
：
‣ 0
：
low level
‣ 1
：
high level
For example
：
AT+SYSIOSETCFG=12,3,1 //set GPIO12 working at GPIO mode
AT+SYSGPIODIR=12,0 //set GPIO12 as input
AT+SYSGPIOREAD=12
6
AT+SYSADC
？
inquire ADC value
Response
：
+SYSADC:<ADC>
OK
<ADC>
：
inquired ADC
value
，
unit
：
1/1024V
For example
：
AT+SYSADC
？
9 Hardware design
It is recommended to use a DC stabilized power supply. The power supply ripple factor is as small as possible and the
module needs to be reliably grounded.
Please pay attention to the correct connection of the positive and negative poles of the power supply, reverse
connection may cause permanent damage to the module.
Please check the power supply to ensure that between the recommended supply voltage, if exceeding the maximum,
the module will be permanently damaged;
Please check the stability of the power supply. Voltage can not fluctuate greatly and frequently;
When designing the power supply circuit for the module, it is often recommended to reserve more than 30% of the
margin, so the whole machine is beneficial for long-term stable operation;
The module should be as far away as possible from the power supply, transformers, high-frequency wiring and other
parts with large electromagnetic interference;
Bottom Layer High-frequency digital routing, high-frequency analog routing, and power routing must be avoided
under the module. If it is necessary to pass through the module, assume that the module is soldered to the Top Layer,
and the copper is spread on the Top Layer of the module contact part(well grounded), it must be close to the digital
part of the module and routed in the Bottom Layer;
Assuming the module is soldered or placed over the Top Layer, it is wrong to randomly route over the Bottom Layer
or other layers, which will affect the module's spurs and receiving sensitivity to varying degrees;
It is assumed that there are devices with large electromagnetic interference around the module that will greatly affect
the performance. It is recommended to keep them away from the module according to the strength of the interference.
If necessary, appropriate isolation and shielding can be done;
