Chengdu Ebyte Electronic Technology Co.,Ltd
Copyright ©2012–2019
，
Chengdu Ebyte Electronic Technology Co., Ltd.
4-11
original data + the short address of the sending device;
5.2.3 Data+Long address
When the output mode is data + long address, after receiving the wireless data, the serial port will output the original
data + the long address of the sending device;
5.2.4 Data+RSSI
When the output mode is data + RSSI, after the module receives the wireless data, the serial port will output the
original data + receive the RSSI value of the data packet;
5.2.5 Data+short RSSI
When the output mode is data + short a RSSI, after receiving the wireless data, the serial port will output
the original data + the short address of the sending the RSSI value of the received data packet;
5.2.6 Data+long RSSI
When the output mode is data + long a RSSI, after receiving the wireless data, the serial port will output the
original data + the long address of the sending the RSSI value of the received data packet;
Note: The maximum packet length supported by the sender for a single packet is 72 bytes.
6.Application function and command configuration
6.1
Function pin
6.1.1 LINK
LINK pin indicates the current network status, after the device is successfully connected to the network, the current
pin is pulled high. When the device has no network or the parent node is lost, this pin is pulled low. The external device
can query the device network status through the pin level.
6.1.2 WAKE
The WAKE pin is mainly used to wake up the dormant terminal. It defaults to a high level when it is powered on.
When the pin is externally pulled down, the dormant terminal device will continue to be awakened. When the pin is
released externally, it will return to high level and enter sleep; Sleep time is determined by the duration of the external
